Supplied free with 2 x quick release davit plates valued at $168 at no extra cost. See below for further information.
Rockboat heavy duty vertical snap davits are used for attaching your inflatable boat to the swim platform which makes it easier and safer, to both mount the outboard motor and also to board the inflatable. The grey rubber pads glue onto the inflatable and the brackets bolt onto the platform. When ready to get underway you simply unhinge it from the davit head and you are free. When returning simply hinge the inflatable back on and the boat can now be swung up out of the water for transport.
Kit Includes:
* 2 x Davit Heads extended by 9.5cm, 316 stainless steel
* 2 x Pads and stainless steel yokes
* 2 x Quick removal plates and pins stainless steel. The plates are fixed onto the platform and the davit heads slide into them and are locked with the pin. When not in use remove the davit head and all that's left behind is the plate.
* 8 x 50mm stainless steel bolts, washers and nuts, for mounting. If mounting platform is thicker than these your will need to purchase your own.
* 4 x 20mm stainless steel bolts with nuts for the yokes.
Glue not included. For davits you should only use the following adhesives due to its strength.
PVC Inflatables
Bostik Unigrip 999 + RFE Desmodur
Hypalon
Bostik 2405 + RFE Desmodur
Up to $50.00 freight is $7.95 for metro and $12.95 for rural delivery (RD)
From $51.00 to $199.00 is $8.95 for metro and $14.95 for rural delivery (RD)
If over $200 freight is $20.00 for metro and rural delivery (RD). Excludes inflatable boats.
We use NZ Post as our courier.
Excluded from above:
Inflatable boats are $79.00 to your nearest Mainstream depot.
Does not include, Stewart Is, Great Barrier etc. Please ask for a quote for these.
International customer please email us with your address and we will provide you with a freight cost.
very good and much cheaper than others on the market
Received in good order thanks and yet to install. I think some information on installation would be helpful (unless I have missed it.) e.g. Do we apply a rubber adhesive to the pads first before the 2 pot is used. Also what should we clean the PVC dingy with before application?
Detailed instructions should have been included with the glue. As you have left anonymous feedback instead of calling or emailing we are unable to know who this is for.
Thanks for subscribing!
This email has been registered!
Take 20% off your first order
Enter the code below at checkout to get 20% off your first order
